Printed in the Federal Republic of Germany TR-Electronic GmbH 2008, All Rights Reserved
06/06/2019 TR - EMO - BA - DGB - 0019 - 08 Page 225 of 252
After pressing the OK button you are finally taken to the relevant node editing window,
where you can assign the device name, for example.
Figure 27: Edit Ethernet Node
To change the device name, the name must be overwritten in the Device name
input field and then confirmed with the Assign Name button.
The new device name is retentively stored in the encoTRives Flash memory, until it is
reset to the default name with the Reset button.
To Next Page
Loading...
