9 2D system measurements
Note – Once you have created the first bucket, the options for the ‘Tilt Bucket’
page change to Yes or No.
If your system uses a:
fixed bucket, select No.
tilt bucket, select the location of the tilting mechanism.
Note – Check that you selected the relevant measurement points during
measure-up. The location of the points can differ if the bucket uses a quick
hitch. For more information, see 9.9 Bucket measurements
5.
Press 7 . The Dimensions dialog relevant to your settings appears.
For fixed buckets or tilting buckets with the bucket sensor mounted on the quick
coupler, you are only required to measure the length G-J and the bucket width:
For tilting buckets with the bucket sensor mounted on the idler arm/ dogbone or
Cat PSC system, you are also required to measure the length G-H:
110 GCS900 GradeControl System for Excavators Installation Manual
To Next Page
Loading...
