Contents
9.9 Bucket measurements 96
9.9.1 G–H / G–J 97
9.9.2 Bucket wear J–J1 98
9.9.3 Bucket width 99
9.9.4 J–K 99
9.9.5 Cat PSC measurements 100
9.10 Machine body measurements 100
9.10.1 Machine width 101
9.10.2 Height of boom pin above ground 101
9.10.3 Boom pin - lateral and reach offset 102
9.11 Machine dimensions 105
9.11.1 Arm/Body Measurements 106
9.12 Create bucket 109
9.13 Arm sensor connections 114
9.14 AS300 / AS45x Sensor Orientation 115
9.15 Calibrate sensors 115
9.15.1 Body sensor calibration 116
9.15.2 Angle sensor calibration 117
9.15.3 Cab rotation sensor calibration 121
10 3D System Measurements 125
10.1 Introduction 126
10.2 GPS receiver over bucket / boom pin 126
10.2.1 GPS receiver over bucket 126
10.2.2 GPS receiver over boom pin 127
10.3 Pole height with pole adaptor 128
10.4 Machine dimensions 129
10.4.1 Boom range pole target to boom centerline 129
10.4.2 Distance from the 3D mast to the back of the machine 131
10.4.3 Body Vector Measurements 132
A Setup Menus 139
A.1 Introduction 140
A.2 Using the setup menus 140
A.2.1 Setup Menu–Configuration 140
A.2.2 Setup Menu – Installation 140
A.3 Machine settings 141
A.4 Units 143
A.5 Cab rotation sensor configuration 143
A.6 External lightbar configuration 144
A.7 Select radio band 145
A.8 Machine radio configuration 146
A.9 Cellular modem configuration 147
A.9.1 Configuring an SNM940 cellular modem 147
A.9.2 Configuring third-party cellular modems 148
12 GCS900 Grade Control System for Excavators Installation Manual
To Next Page
Loading...
Need help?
General