Contents
A.10 Control box’s radio port 150
A.11 GNSS receiver configuration 151
A.12 Select bucket 152
A.13 Bucket wear 153
A.14 Laser catcher support 154
A.15 Diagnostics 155
A.16 Saving the settings 156
B Machine Configurations 157
B.1 Introduction 158
B.2 Device settings 158
B.3 System assemblies 158
B.4 Using a laser catcher 159
B.5 Tilt bucket kit 159
B.6 VA Boom kit 160
B.7 Excavator calibration kit 160
B.8 Cab rotation sensor kit 161
C Validation and Troubleshooting 163
C.1 Introduction 164
C.2 Validating the cabling installation 164
C.3 Validating the tilt bucket 164
C.4 Validating the bucket guidance 165
C.5 Checking the arm lengths 166
C.6 Checking device connections 166
C.7 Checking the lightbars and control box 167
C.8 No power 167
C.9 No CAN bus connection 168
C.10 Related information 169
D Using a USBFlash Drive for File Transfer 171
D.1 System memory and the USB flash drive 172
D.2 Transferring data to and from the control box 173
E Radio Declarations 177
E.1 SNR2400 data radio declaration 178
E.1.1 Notices 179
E.1.2 Japanese approval 180
E.2 SNRxxxdata radio 181
E.3 450 MHz data radio 182
E.4 900 MHz data radio 182
GCS900 Grade Control System for Excavators Installation Manual 13
To Next Page
Loading...
