D Using a USBFlash Drive for FileTransfer
Transferring files to the USB flash drive
Note – If a file or folder to be transferred already has an item with a matching file
name, but different contents on the USB flash drive, the destination item will be
renamed to a backup name generated by appending the item’s last-modified date to
its file name.
1. Press To USB.
Only files that have been generated or modified on the control box transfer to
the “Machine Control Data” folder on the USB flash drive and are written to
the machine’s sub-folder. The machine’s sub-folder name is the same as the
machine name set on the control box.
The following table describes the action that is applied to each file type during
a file transfer to the USB flash drive.
File type Copy Move
Design files
P
Map design files
P
Slope design files
P
Level design files
P
Profile design files
P
Program log files
P
ZSnap and .gif files
P
Production .tag files (when 2-way data communication IS NOT enabled)
P
Production .tag files (when 2-way data communication IS enabled)
P
Points .csv files
P
RemoteBase.txt file
P
Note – A copy action copies the file and leaves the original file on the control
box. A move action copies the file and deletes the original file from the control
box.
A progress bar appears, showing the progress of the data transfer.
2.
To exit, press \ or remove the USB flash drive.
Transferring files from the USB flash drive
Two types of file transfer from the USBflash drive are available:
174 GCS900 GradeControl System for Excavators Installation Manual
To Next Page
Loading...
