Using a USBFlashDrive for File Transfer D
l Add from USB
l Overwrite from USB
Add from USB
Note – If a file or folder to be transferred already has an item with a matching file
name, but different contents on the display, the destination item will be renamed to a
backup name generated by appending the item’s last-modified date to its file name.
Files and folders matching this backup naming convention, generated by a previous
“to USB” operation, will NOT be transferred from the USB flash drive to the
display.
1. Press Add from USB.
Data in the “\Machine Control Data\MachineName” folder and sub-folders,
and the “\Machine Control Data\All” folder of the USB flash drive transfers to
the control box.
A progress bar appears, showing the progress of the data transfer.
2.
To exit, press \ or remove the USB flash drive.
Overwrite from USB
Note – Use with caution, as this transfer deletes all existing files from the control
box.
1. Press Overwrite from USB. The following actions occur:
a. A warning is displayed. Read the warning message carefully and only
press \ if you are sure you want to continue.
b. The control box is backed up. All current files on the control box are saved
to a backup folder on the USB flash drive. Your site supervisor can restore
from backup.
c. The entire data content is deleted from the control box.
d. Data in the “\Machine Control Data\MachineName” folder and sub-
folders, and the “\Machine Control Data\All” folder is transferred from
the USB flash drive to the control box.
A progress bar appears, showing the progress of the data transfer.
2.
To exit, press \ or remove the USB flash drive.
Data transfer error messages
When transferring data, a warning message appears when there is insufficient
space on either the control box or the USB flash drive.
GCS900 Grade Control System for Excavators Installation Manual 175
To Next Page
Loading...
