Before you maneuver the machine, make sure that no personnel are between the
machine and the trailing equipment.
Always keep the Rollover Protective Structure (ROPS) installed during machine
operation.
Monitor the location of components that are mounted to the blade. Ensure that the
components do not come into contact with other parts of the machine during
operation.
Warnings
WARNING — When replacement parts are required for this product Trimble recommends
using Trimble replacement parts or parts with equivalent specifications including, but not
limited to, physical dimensions, type, strength and material. Failure to heed this warning can
lead to premature failures, product damage, personal injury or death.
WARNING — To prevent possible personal injury during installation and removal of the
laser receivers, lower the mast to the minimum height and use an approved access system
to reach the mounting locations of the laser receivers at the top of the mast. Do not climb on
the machine.
WARNING — In order to prevent personal injury during installation and removal of a GNSS
receiver or a UTS target, use an approved access system in order to reach the mounting
locations of the GNSS receiver or UTS target at the top of the mast.
WARNING — Disconnect the negative battery terminal before commencing any welding.
Ensure that power is removed from the system by disconnecting the power input cable(s).
Failure to follow this warning may result in electric shock.
8 GCS900 Grade Control System for Excavators Installation Manual
Safety Information
To Next Page
Loading...
Need help?
General