CHAPTER 6: System Configuration
96 Vcontroller
for redundancy and transparent failover in the case
of a hardware failure. HA ports are connected
between Vclass appliances, and not to the network.
The HA2 ports can be connected to each other for
greater redundancy, or you can use the HA2 ports
as direct management connections. For more
information, see “Setting Up a High Availability
System” on page 425.
This interface is not available on the V10 model.
High Availability is not supported in Transparent
Mode.
If you need to make any changes to the configuration of the
interfaces, use the following instructions.
Configuring Interface 0
To edit the interface settings:
1 Select the interface entry and then double-click.
The Edit Interface dialog box appears.
To Next Page
