Watchguard V10 - Configure the Interfaces in Transparent Mode

Running the Vcontroller Installation Wizard
Firebox Vclass User Guide 45
will need to login again, using the new IP address
information, to continue configuring the appliance. For
information on configuring the appliance without
using the Installation Wizard, see “System
Configuration” on page 89.
Configure the Interfaces in Transparent
Mode
In Transparent Mode, the Firebox Vclass is given a single
System IP and System Subnet Mask. These addresses are
used for all interfaces on the system. For more information
on Transparent Mode, see “Router and Transparent Mode”
on page 79.
To configure interfaces in Transparent Mode:
1 Click Next from the General window of the installation
wizard, or click the Interfaces tab.