CHAPTER 3: Getting Started
24 Vcontroller
4 When that window’s contents appear, double-click the
setup.exe icon to start the installation of the
Vcontroller software.
5 If the installer detects an older version of the software,
it will prompt you to remove the older version.
Remove all installed components, and when the
installer has finished removing the components, run
setup.exe again.
6 When the process is finished, a window appears,
prompting you to start Vcontroller.
Installing Vcontroller on a Solaris
workstation
Before you install Vcontroller software, make sure you
gather all of the network addressing information that will
represent your new Firebox Vclass security appliance. Use
the notes you completed in the previous section, “Gather-
ing Network Information” on page 22.
N
OTE
Be sure to review the release notes that were included in this
package for information about Solaris-Java issues, including
the Solaris and JRE versions. For additional updates, check
the WatchGuard Web site.
To install Vcontroller:
1 Insert the WatchGuard CD into the CD-ROM (in
Solaris, the CD should automatically mount at /
cdrom).
2 Start the installer application by entering the following
commands:
cd /cdrom/watchguard
./setup.sh
3 The installer asks whether you have already installed
the latest versions of the Java Run-time Environment
(JRE) and Java Software Development Kit (JDK). If you
have, type Y and then type the pathways of the JRE
and JDK directories.
To Next Page
Loading...
