CHAPTER 6: System Configuration
114 Vcontroller
3 Click Add.
The DNS Server dialog box closes and the new server IP address
appears in the DNS Server list.
To manage the DNS server entries:
• To edit a DNS server IP address, select the entry from
the DNS Server List and click Edit.
• To delete a DNS server IP address, select the entry from
the DNS Server List and click Delete.
• If you have more than one server in the list, you can
reorganize the search order by choosing a server entry
and then clicking Up or Down.
When you have finished configuring the DNS settings,
click one of the following options:
Reset
To return the settings to the previous configuration.
Apply
To immediately apply the settings to the Firebox
Vclass appliance.
SNMP Configuration
Use the SNMP tab to add the IP addresses of management
stations that will be monitoring this appliance. You also
use these fields to record the relevant SNMP community
string. For a complete list of supported MIBs for Firebox
Vclass appliances, review the MIB files that are stored on
the WatchGuard CD.
Because Firebox Vclass appliances support the SNMP ver-
sion 1 protocol, you can assign an SNMP community to
this Firebox Vclass appliance so that it can be managed
through SNMP management stations. You can also config-
ure this appliance so that an SNMP trap will be sent to all
related management stations when an alarm is triggered.
However, to retrieve SNMP MIB counters from a Firebox
To Next Page
