CHAPTER 14: Monitoring the Firebox Vclass
366 Vcontroller
5 Click Add when you are finished configuring this
probe.
The Select Probe window closes and the new probe is displayed in
the appropriate tab list.
6 Repeat these steps to add more probes.
7 Click Done when you are finished.
To edit the settings of an existing probe:
1 Select the probe and click Edit.
2 When the Select Counter window appears, you can
use its features to switch counters as needed. If you
need to add a second counter to monitor a specific
policy, you may need to click Add to create an new
probe.
3 When the probe has been edited, test it by clicking
Show Monitor (in the Real-time Monitor window) and
then click Start Monitoring to activate the graphic
display.
To disable an existing probe:
1 Click the tab for the probe you want to disable.
2 Select the Enabled checkbox.
The checkmark disappears. Disabling a probe is temporary; you
can re-enable a probe at any time.
To delete an existing probe:
1 Click the relevant tab for the probe you want to delete.
2 Select the probe you want to delete and then click
Delete.
Monitoring configured probes
To view the actual level of activity of all the listed probes in
one of the tabs:
1 Click the tab for the probes you want to monitor.
2 Click Show Monitor.
The Real-time Charts window appears.
To Next Page
