Watchguard V10 - Enabling Tunnel Switching

CHAPTER 11: Using Virtual Private Networks (VPN)
326 Vcontroller
N OTE
Tunnel switching is not available on the V10 model, or in
Transparent Mode.
Enabling tunnel switching
Before you set up individual VPN policies for site-to-site
tunnel switching, you must activate tunnel switching in
the Firebox Vclass appliance hardware (which is disabled
by default). To do so:
1 Open the Policy Manager window.
2 Click the Tunnel Switch button in the left margin (this
button is not available on the V10 or in Transparent
Mode).
The System Tunnel Switching dialog box appears.
3 Select the Enable Tunnel Switching checkbox.
4 Click OK.