Resetting an Appliance Completely
Firebox Vclass User Guide 409
connected to (e.g. COM1, COM2). Use the following
settings to connect to the Vclass device:
- Bits per Second: 9600
- Data Bits: 8
-Parity: None
- Stop Bits: 1
- Flow Control: None
3 Reset the device, and wait until you see the following
text:
Loading linux-wg...
4 Press Escape immediately. If you miss it and see the
line
Continue Booting...
reset the device and try again.
5 You will see the following message:
Please Enter Serial Number -->
Enter the system serial number. This field is case
sensitive. Enter the system serial number again when
prompted.
6 The following message appears:
SUCCESS: Database and password were reset
to factory default.
Continue Booting...
7 Wait five minutes, turn off the device, then start the
system again.
The Vclass device is now completely reset. The login and
password for the device is reset to “admin/admin,” the interfaces
are reset to default addresses, and all configuration data is
deleted.
To Next Page
