Watchguard V10 - Page 58

CHAPTER 3: Getting Started
26 Vcontroller
To install Vcontroller:
1 Insert the WatchGuard CD into the CD-ROM.
2 Start the installer application by entering the following
commands:
mount /dev/cdrom -t iso9660 /mnt/cdrom
cd /mnt/cdrom
./setup.sh
3 The installer asks whether you have already installed
the latest versions of the Java Run-time Environment
(JRE) and JDK. If you have, type Y and then type the
pathways of the JRE and JDK directories.
N OTE
If you have an older version of JDK, the installer asks
whether you prefer to use it instead of a more recent version.
WatchGuard recommends that you install the most recent
version.
4 If you have not installed JRE or JDK, type N. The
installer quits, but provides information on where to
obtain the most current versions of JRE and JDK
software from the Sun Web site.
5 When the JRE and JDK software has been installed and
any required Linux updates are completed, start the
installer application again by entering the following
commands:
cd /cdrom/watchguard
./setup.sh
6 When asked by the installation script for the directory
location of the JRE and JDK, enter the appropriate
pathway.
7 Vcontroller installation is complete. To launch
Vcontroller enter the following command:
Vcontroller
Be certain the directory containing Vcontroller software is listed
in the PATH environment variable.