CHAPTER 3: Getting Started
58 Vcontroller
If you have a V10, disconnect the power cord to turn
off the appliance.
9 Disconnect all the cables and move the appliance to its
permanent network setting.
After you place the appliance in its permanent location and
make the necessary physical network connections, you can
restart the appliance.
• Use the power cord to connect the appliance to a UPS
device or to a protected outlet.
• For a V10, make sure that you connect the power cord
to the V10 before you connect it to the AC outlet or the
UPS device. This will start the V10 appliance.
• For all other models, turn on the power with the switch
on the back of the appliance.
When the appliance has started, the Ready LED blinks
while the initialization process occurs. When
initialization is complete, the Ready LED remains lit.
To Next Page
Loading...
