Xerox WorkCentre 5020 - REP 5.1.2 Temperature Control Sensor Assembly

July, 2007
4-31
WorkCentre 5020
REP 5.1.2
Repairs and Adjustments
Initial Issue
REP 5.1.2 Temperature Control Sensor Assembly
Parts List on PL 5.1
Removal
WARNING
To avoid personal injury or electrical shock, ensure that the machine is completely off
before disassembling or adjusting. Turn OFF the power and unplug the machine.
WARNING
The Fuser and Exit Transport are hot. Do not work on them until they are cool enough.
1. Remove the Fuser (REP 5.1.1).
2. Slide the Cover to the left and remove (Figure 1).
Figure 1 Removing the Cover
3. Remove the Temperature Control Sensor Assembly (Figure 2).
1 Remove the Screw.
2 Remove the Harness.
Figure 2 Removing the Temperature Control Sensor Assembly
Cover
Screw
Harness