July, 2007
2-3
WorkCentre 5020
Status Indicator RAPS
Initial Issue
Fault Repair Overview and List of Error Codes
Fault Repair Overview
The fault repair operation proceeds in the following flow. After performing the pre-check, verify
the symptoms and refer to the Error Code List and Section 7 Wiring Data to effectively repair
the fault:
.
Figure 1 Troubleshooting Procedure
Check the status of Installation
Check the problem status
Perform RAP
Check if the fault is repaired
Completed
Diagnostic Mode
Operating Principles
Wiring Data
Reference
Information
To Next Page
Loading...
