| Configuring Video Settings | 143
• Configuring 1+N Mode
Configuring the Average Mode
In Equal N×N layout, when the number of participants exceeds 9, all participants’ video images will be
switched automatically. You can configure the switching mode.
Procedure
1. On your web user interface, go to Setting > Built-in MCU Setting > Video Layout > Average Mode.
2. Configure and save the following settings:
Parameter Description Configuration Method
View Switching Interval
Configure the view switching
interval.
Note: the default value is 30
seconds.
The video images will be
switched automatically every 30
seconds.
Web user interface
Single View Round Switches one video image at a
time.
Web user interface
Full Screen Round Switches all video images at a
time.
Web user interface
Configuring 1+N Mode
In Speaker View layout and 1+N layout, up to 8 video images can be displayed. When the number of
participants exceeds 8, all participants’ video images will be switched automatically. But the video images of
active speaker and the content are not be switched.
Procedure
1. On your web user interface, go to Setting > Built-in MCU Setting > Video Layout > 1+N Mode.
2. Configure and save the following settings:
Parameter Description Configuration Method
View Switching Interval
Configure the view switching
interval.
Note: the default value is 30
seconds.
The video images will be
switched automatically every 30
seconds.
Web user interface
View Round
Configure the number of video
images to be switched at a time.
Note: the default value is 1.
Valid value: 1 - 7.
Web user interface
To Next Page
Loading...
