Getting Started
18
guidelines is particularly important for the proper use of this device. The manufacturer assumes no liability for
any and all damages that can be attributed to non-compliance with these guidelines.
Initial Operation Safety Considerations
• Installation/Initial Operation - Perform VC8300 installation in accordance with Installation on page 24.
Specifically, pay special attention to the various electrical potentials of the vehicle. Some vehicles have a
chassis that is connected to one of the battery supply lines (DC+ or DC-), while most electrically-driven
forklift vehicles have floating chassis, connected to neither DC+ or DC-. See Wiring Vehicle Power to the
VC8300 on page 26 for required wiring of vehicle power and fusing for the VC8300.
• Risk of injury during transit or installation - The unit can fall during transit or installation and cause injury.
Always ensure that there are two persons available when installing or removing the device.
• Ensure that no persons are injured in case the mounting bracket breaks - The VC8300 may not be installed
in such a way that persons can be injured during a breaking of the mounting bracket (e.g. fatigue break). If
the device is mounted in a place where people can be injured if the bracket breaks, apply appropriate safety
measures (e.g. install a security cable in addition to the device bracket).
Power Supply/Cable Safety
The main power cord shall comply with the national safety regulations of the country where the equipment is to
be used.
• Operation in an emergency - In case of an emergency (such as damage to the power cable or housing, or
ingress of liquid or other foreign bodies), disconnect the device immediately from the power supply. Contact
technical support staff at once.
• Protection of the power supplies - If, after replacement, the fuse fed by the internal power supply blows,
send the device for servicing immediately.
• Danger of electrocution when cleaning/servicing the device - In order to avoid electrocution, always
disconnect the VC8300 from the power supply before cleaning or servicing the device.
• Do not exceed maximum voltage when charging the vehicle battery - While charging the vehicle battery,
disconnect the VC8300 from the battery or ensure that the maximum allowed input voltage of the VC8300 is
not exceeded.
• Do not switch on devices with damaged cables or plugs - Do not use the VC8300 if a cable or plug is
damaged. Replace damage parts immediately.
• Do not connect or disconnect cables during storms - Cables must never be connected or disconnected
during an electrical storm.
External Devices Safety
The use of additional wiring and other peripheral devices, which are not recommended or sold by the
manufacturer, can result in fire, electrocution or personal injury.
• If a power supply is used, only use the power supply recommended by the manufacturer.
• Before connecting or disconnecting peripheral devices (exception: USB devices), disconnect the VC8300
from the power supply to avoid serious damage to both the VC8300 and the connected devices.