– enable multiple user authentication via the card reader Multiple authentication
(or the user authentication option defined in ). Disable multiple Directory / Users
authentication for a card reader to cancel code authentication via the numeric
keypad.
– set the number of the switch to be activated by tapping of a Associated switch
valid RFID card. The set value is not applied when a valid user card is tapped on
the reader while the double authentication mode is enabled. In this case, a
numeric switch activating code is required to identify the switch to be
activated.)
– set one of the card reading signalling modes:Read signalling
– acoustic signals distinguish valid/invalid cardsFull
– one beep signals both valid and invalid cardsSingle beep
– acoustic signalling is disabledNone
– select one or more card types to be accepted. If no Allowed card types
selection is made, all types of supported cards are accepted.
– set a group of Wiegand outputs to which all the Forward to Wiegand output
received RFID card IDs will be resent.
Bluetooth Module
Module name – set the module name for logging events from the Bluetooth
module.
Direction – set the reader direction (Not specified, Arrival, Departure) for the
Attendance system purposes.
To Next Page
Loading...
Need help?
General
