List of Parameters
Device name – set the device name to be displayed in the right upper corner of
the web interface, login window and other applications if available (2N
®
Network Scanner, etc).
Web interface language – set the default language for administration web server
login. Use the upper toolbar buttons to change the language temporarily.
Password – set the intercom access password. Press to change the password.
The 8-character password must include one lower-case letter, one upper-case
letter and one digit at least.
HTTP port – set the web server port for HTTP communication. The port setting
will not be applied until the intercom gets restarted.
HTTPS port – set the web server port for HTTPS communication. The port
setting will not be applied until the intercom gets restarted.
HTTPS user certificate – specify the user certificate and private key for the
intercom HTTP server – user web browser communication encryption. Choose
one of the three sets of user certificates and private keys (refer to the
Certificates subsection) or keep the setting, in which the certificate SelfSigned
automatically generated upon the first intercom power up is used.
Remote access enabled – enable remote access to the intercom web server from
off-LAN IP addresses.
To Next Page
Loading...
Need help?
General
