Multiple authentication – enable multiple user authentication via this module (or,
authentication is controlled by the user card settings; refer to Directory / Users).
Multiple authentication can be disabled for each reader connected to the
intercom.
Associated switch – set the number of the switch to be activated after user
authentication via this module.
Read signalling – set one of the sound signalling modes for the module:
Full valid and invalid accesses are distinguished by sound signalling–
Single beep valid and invalid accesses are signalled by a single beep–
None module use is not signalled by any sound–
Signal range – set the maximum signal range, i.e. the distance within which the
Bluetooth module can communicate with the mobile phone:
Short – less than 50 cm for most phones
Middle – less than 2 m for most phones
Long – maximum possible range
Operation mode – set the authentication method for a mobile phone:
Tap in app – authentication has to be confirmed by tapping on an icon in
the application running in a mobile phone
Touch mode – authentication has to be confirmed by moving the hand to
the Bluetooth module installed
Proximity mode – authentication is executed automatically when the
mobile phone is within the Bluetooth module signal reach
I/O Module Configuration
Module name – set the module name for input/output specification in the
SetOutput, GetInput and InputChanged objects in .Automation
Wiegand Module Configuration
To Next Page
Loading...
Need help?
General
