Tone Meaning
Profile deactivated
This tone signals profile deactivation. This function helps, for example,
disable alerting of a user group in an office and routing calls either to a pre-
defined phone number (porter's lodge, e.g.) or user mobile phones. Refer to
the Profile subsection for the deactivation code settings.
Call prolongation confirmation signalling
Calls are time-limited in for security reasons (protection 2N IP intercoms
against blocking). Refer to the Miscellaneous subsection for details.
Internal application launched
The internal application is launched upon power up or 2N IP intercom
restart. A successful launch is signalled by this tone combination.
Connected to LAN, IP address received
2N IP logs in upon the internal application launch. A successful intercom
LAN login is signalled by this tone combination.
Disconnected from LAN, IP address lost
This tone signals UTP cable disconnection from . 2N IP intercom
Disconnection is signalled by this tone combination.
Invalid telephone number or invalid switch activation code
2N IP intercom allows the user to dial an extension number directly using
the keypad or enter the door unlocking code. An invalid code is signalled by
this tone sequence.
Default reset of network parameters
Upon power up, a 30 s timeout is set for the default reset code entering.
Refer to the Device Configuration subsection in the 2N IP intercom
Installation Manual for details.
To Next Page
Loading...
Need help?
General
