5.3.6 Buttons
Assign the Directory / Users users to the quick dial buttons. By default, all available
intercom buttons are assigned to the listed users. A non-assigned button can be used
for automation or switch activation, for example.
Button function during call – set the quick dial button function during a call. You
can only set the button that initiated the call. The following options are available:
None – button pressing does not affect the call setup or active call.
Hang up – button pressing terminates the call setup or active call.
Dial the following – button pressing initiates dialling of the following user
number in the users list. This accelerates the dialling process in case the
user is inaccessible on some of its phone numbers.
Flash – button pressing sends a special DTMF character (FLASH) into the
current call, to which the connected PBX can response with the selected
action.
Restore network settings by buttons – enable restoration of the default network
settings by pressing a sequence of the quick dial buttons after the intercom
restart as described in the subsection in the Installation Device Configuration
Manual of the respective model.
To Next Page
Loading...
Need help?
General
