5.4.10 Audio Test
The allow you to perform periodical tests of the integrated speaker 2N IP intercoms
and microphone. For the test purpose, the integrated speaker generates one or more
short beeps. The integrated microphone receives the generated tone and the test is
successful if the tone is detected correctly. The test takes approximately 4 seconds. If
the test fails (which may be due to an extreme surrounding noise level, e.g.), a new
test is carried out in 10 minutes. The result of the last test can be displayed in the
intercom confirmation interface or processed by the Automation
.
Note
The audio test is available with the Gold or Enhanced
Audio licence only.
If a call is active when the audio test starts, the audio test will be put off
until the call is terminated. The audio test will be performed the moment
the call is terminated.
To Next Page
Loading...
Need help?
General
