Each user can be assigned a private switch activation code. The user switch codes can
be arbitrarily combined with the universal switch codes defined in the Hardware |
menu. If the codes are identical with the codes already defined in the Switches
intercom configuration, the mark will appear at the colliding codes.
Code – set a private user switch activation code: up to 16 characters including digits 0–
9 only.
Each of the intercom users can be assigned one access RFID card.
Card ID – set the user access card ID: 6–32 characters including 0–9, A–F. Each
user can be assigned just one access card. When a valid card is tapped on the
reader, the switch associated with the card reader gets activated. If the double
authentication mode is enabled, the switch can only be activated using both a
card and numeric code.
Tip
The user card ID can also be entered via an external USB card reader
(Part No. 9137421E).
Press and swipe the card through the USB card reader. The card
number will be automatically entered into the Card ID field.
Make sure that a PC driver is installed to make the USB card reader work
. properly. Refer to www.2n.cz
User Fingerprint Setting Instructions
Fingerprint reading is possible via an external USB fingerprint reader (Part No.
9137423E). The procedure is as follows:
1) Go to the settings, select the Fingerprint reader (Biometric reader) 2N USB Driver
and click OK for confirmation.
To Next Page
Loading...
Need help?
General
