User deputy – select a user to which the user calls will be routed in the event of
inaccessibility. Enter user position number or use search button. The deputy
setting is applied when the user fails to answer the call to any of its phone
numbers within the predefined timeout, or if the user numbers are inaccessible
for other reasons (time profiles, user deactivation).
Note
The User Deputy function is available in selected 2N IP intercom models
).only (refer to the model and licence overview
Each user is assigned an access mode for intercom authentication.
Access profiles assign an access profile to a user Auth ID to control its validity. –
If the profile is inactive, the user Auth ID is considered invalid. If multiple profiles
are assigned at the same time, Auth ID is valid only if one of the profiles is active
at least.
Authentication mode – set the authentication mode for a user - either simple or
a combination of the user card, numeric code and fingerprint, depending on
which authentication devices are installed. To activate the switch in the multiple
authentication mode, it is necessary to perform all the selected authentication
actions sequentially in ten-second intervals.
Valid from – set the beginning of the mode validity term.
Valid to – set the end of the mode validity term.
To Next Page
Loading...
Need help?
General
