Transmitted code format set the format for the codes to be transmitted –
(Wiegand 26, 32, 37 and RAW).
Change Facility Code – set the first code part via Wiegand. This applies to
Wiegand OUT for 26-bit code format. Contact your security PBX supplier to
know if the Facility Code is requested.
Facility Code – define the intercom location in the security PBX system. 2N IP
Enter a decimal value for the location (0–255).
– set the passage direction for the card reader (Not Specified, In, Out) Direction
for the attendance system purposes .
Service Cards
Service cards are two common cards that are dedicated to this particular purpose by
you. Be sure to complete their IDs in the Plus card ID and Minus card ID items in this
section. The count of access card ID characters is given by the card type and is
variable. However, it holds true that all cards of the same type have equally long IDs.
To add a card to the list, apply the plus card and then tap the card to be added on the
reader. The RFID card will be added if the list is not full and does not include the card
yet.
To remove a card from the list, apply the minus card and then tap the card to be
removed on the reader. The RFID card record will be cancelled and access via this
card will be blocked.
Plus card ID – enter the service card ID for adding cards to Installed cards: a
sequence of 6 to 32 characters including 0–9, A–F.
Minus card ID – enter the service card ID for removing cards from Installed cards:
a sequence of 6 to 32 characters including 0–9, A–F.
To Next Page
Loading...
Need help?
General
