Module name set the module name for input/output specification in the –
SetOutput, GetInput and InputChanged objects in the settings.Automation
Direction – set the passage direction for the card reader (Not Specified, In, Out)
for the attendance system purposes.
enable multiple user authentication via a Wiegand-Multiple authentication –
connected card reader (or the user authentication option defined in Directory /
). Disable multiple authentication for a card reader to cancel code Users
authentication via the numeric keypad.
Associated switch set the number of the switch to be activated whenever a –
valid code is received .
Received code format set the format for the codes to be received (Wiegand –
26, 32, 37 and RAW).
Card read signalling – set one of the card reading signalling modes:
acoustic signals distinguish valid/invalid cardsFull –
one beep signals both valid and invalid cardsSingle beep –
acoustic signalling is disabled.None –
Forward to Wiegand output set the group of Wiegand outputs to which all the –
received codes will be resent .
Transmitted code format set the format for the codes to be transmitted –
(Wiegand 26, 32, 37 and RAW).
Output Wiegand group assign the output Wiegand group to which the codes –
from the connected card readers or Wiegand inputs can be resent.
Induction Loop Module Configuration
Maximum power – set the maximum transmission power for the induction loop
antenna. A higher transmission power means a wider range, but less power for
other intercom functions. The convenient default value is 0.25 W under normal
circumstances.
To Next Page
Loading...
