IP Eye address – set the address of the PC to be sent a special UDP message on
each active user phone number call. With the aid of this message, the 2N IP Eye
®
application displays the camera image screen for those users who are not
provided with a display-equipped videophone. Enter the address as follows:
domain[: ][: ], e.g.: or 192.168.22.111. The port1 port2 computer.yourcompany.com
and parameters are optional and are used in case there is Network port1 port2
Address Translation (NAT) between the PC and intercom and the addresses
have to comply with the router or another NAT-executing device. The port1
(default value: 8003) parameter defines the destination port for the UDP
messages sent to . The port2 (default value: 80) parameter defines 2N IP Eye
®
the destination port for the – intercom HTTP communication.2N IP Eye
®
Note
The 'IP Eye Address' function is available in selected 2N IP intercom
models only (refer to the model and licence overview).
When Enhanced Integration is not licensed on a device, it is possible to
control the locks only when a call is in progress. If a call with user, who
has address filled in, is in progress, no licence is needed to 2N IP Eye
®
control the locks.
Tip
FAQ: 2N IP Eye – How to set
®
Tip
Video Tutorial: SW application for IP intercoms – 2N IP Eye
®
Parallel call to following number – enable group calling, i.e. calling to more phone
numbers at the same time. You can call the first two numbers, the last two
numbers, or all of the three user numbers in parallel. Answering one call
automatically terminates the other calls.
Parallel call to following deputy – extend group calling to include the User
deputy.
To Next Page
Loading...
