Time profile – choose one or more time profiles to be applied. Set the time
profiles in Directory / Time profiles.
Authentication mode – set the authentication mode for the time profile in this
row including multiple authentication for enhanced security. Select Access
denied to ban access.
Zonal code – enable the zonal code for the time profile and authentication
combination in this row. You can use the zonal code instead of the user PIN.
REX button – enable the exit button function for the selected time profile. Set
the exit button input in Hardware / Door / Door tab.
Zonal code – enter the switch numeric zonal code consisting of two characters
at least. However, four characters at least are recommended.
Authentication signalling – select how to signal that a card or another identifier
has been read. The available modes are None (no signalling at all), Single Beep
(single beep regardless of whether the identifier was valid or not) and Full
(sound indicating the validity).
Virtual card to Wiegand – select a group of Wiegand outputs to which the
Virtual user card No. shall be sent after successful authentication. Can be
combined with any authentication method, including codes, fingerprints, etc.
Silent alarm enabled – a virtual code higher by 1 than the access code is assigned
to each access code and used for silent alarm activation. For example, if the
access code is 0000, then the silent alarm activation code is 0001. It means, for
instance, that silent alarm is 0000 for access code 9999 and so on. Set the silent
alarm action in the Automation section.
To Next Page
Loading...
Need help?
General
