QoS DSCP value – set the video RTP packet priority in the network. The set
value is sent in the TOS (Type of Service) field in the IP packet header.
Maximum packet size – set the size limit for the video RTP packets to be sent.
H.264 payload type (1) – set the payload type for video codec H.264
(packetisation mode 1). Set a value from the range of 96 through 127, or 0 to
disable this codec type.
H.264 payload type (2) – set the payload type for video codec H.264
(packetisation mode 2). Set a value from the range of 96 through 127, or 0 to
disable this codec type.
H.263+ payload type – set the payload type for video codec H.263+
(packetisation mode 3). Set a value from the range of 96 through 127.
Polycom compatibility mode – set SDP compatibility with some earlier Polycom
and Cisco phone models. If this mode is on, the intercom does not send the
flag in the SDP message in the video codec offer.sendonly
Tip
For the Video Preview feature at the phone Grandstream GXV 3275
(video transferred via Early Media) no configuration is needed. Check
your PBX vendor whether this feature is supported by your PBX system.
For the Video Preview feature at the phone (video Gigaset Maxwell 10
transferred via jpg images) it is necessary to set toConnection Type
and to at the in Unsecure Authentication None Camera API HTTP API.
2N ® Indoor Touch Tab