1. a.
b.
c.
d.
Be sure to set one user account at least and the proper access level (according to
ONVIF specification and used VMS) to achieve . Without this, full ONVIF functionality
the basic functionality is only available.
Enabled – e nable/disable the user account.
Name – set the ONVIF access user name.
Password – set the ONVIF access password.
Access level – set the user ONVIF access level (User, Operator,
Administrator).
Output type – set the inverted logic input control mode via ONVIF.
Note
Check the following RTSP and JPEG functions for enable to make the
ONVIF function work properly (to gain full compatibility with the third
party equipment):
on the RTSP tabRTSP Server enabled
RTSP tabVideo stream enabled on the
o RTSP tab UDP unicast enabled n the
o JPEG tabSnapshot download enabled n the
Note
Preset authorisation for ONVIF
Username: admin
Password: 2n