copy 265
Copying an Image File from a Server to Flash Memory
To copy an image file from a server to flash memory, use the copy
source-url image command.
Copying a Boot File from a Server to Flash Memory
To copy a boot file from a server to flash memory, enter the copy
source-url boot command.
Copying a Configuration File from a Server to the Running
Configuration File
To load a configuration file from a network server to the running
configuration file of the device, enter the copy source-url
running-config command. The commands in the loaded configuration
file are added to those in the running configuration file as if the
commands were typed in the command-line interface (CLI). Thus, the
resulting configuration file is a combination of the previous running
configuration and the loaded configuration files with the loaded
configuration file taking precedence.
Copying a Configuration File from a Server to the Startup
Configuration To copy a configuration file from a network server to
the startup configuration file of the device, enter copy source-url
startup-config. The startup configuration file is replaced by the copied
configuration file.
Storing the Running or Startup Configuration on a Server
Use the copy running-config destination-url command to copy the
current configuration file to a network server using TFTP. Use the copy
startup-config destination-url command to copy the startup
configuration file to a network server.
Saving the Running Configuration to the Startup Configuration
To copy the running configuration to the startup configuration file, enter
the copy running-config startup-config command.
To Next Page
Loading...
