Call routing
262
System functions and features as of R3.0
syd-0367/1.3 – R3.0 – 03.2013
Tab. 86 Settings for PINX 2 routing parameters
Tab. 87 Settings for PINX 1 routing parameters
Phone number with an exchange access prefix
If the phone number has an exchange access prefix without route information (Ex-
change access business, Exchange access private, Cost centre selection), the call will be
routed on via the transit route.
If the phone number has a route selection prefix, the call will be routed via the cor-
responding route.
Note:
If a number has a route selection prefix and if NPI is E.164, the call will be
routed via the transit route without truncating the prefix.
Parameter Parameter value
Route 1:
• Trunk groups 1 (reference number of one or more trunk group(s))
• Numbering plan identifier NPI E.164
• Type of number TON Unknown
• Send access code –
Trunk group 1:
• Network interfaces Network interfaces of this trunk group
• Network type Private
• Protocol PSS1 (QSIG)
Parameter Parameter value
Basic setup PISN:
• Transit route: 1 (route reference number for transit calls to the public network)
Route 1:
• Trunk groups 3 (reference number of one or more trunk group(s))
• Digit barring Use or do not use digit barring
• Outgoing connections Number of connections allowed simultaneously
• Numbering plan identifier NPI E.164
• Type of number TON Unknown
• Send access code –
Trunk group 1:
• Network interfaces Network interfaces of this trunk group
• Network type Public
• Protocol DSS1
To Next Page
Loading...
