Appendix A - 57
Error Messages
Electrical
Troubleshooting Guide
IRB6400 M94A
40614: Argument error............................User's Guide
Argument %s is not 0 or 1.
Digital output signals can only be set to 0 or 1.
4061S: Argument error............................User's Guide
Argument %s is not an integer value.
Digital group of output signals can only have an integer value.
40616: Argument error............................User's Guide
Argument %s is outside allowed limits.
Used group of digital output signals can only be set within 0 to %s according configuration
in the system parameters.
40617: Argument error............................User's Guide
Argument %s is outside allowed limits.
Used analog output signals can only be set within %s to %s according configuration in the
system parameters.
40618: Argument error............................User's Guide
Argument %s contains an illegal interrupt number.
Input interrupt number is illegal because it has not been allocated by the instruction
CONNECT.
40619: Argument error............................User's Guide
Argument %s contains an interrupt number, which is already in use for other purpose.
Before reuse of an interrupt variable again in the program, cancel old interrupt generation
and interrupt number with instruction Delete.
40620: Argument error............................User's Guide
Argument Interrupt has negative value for ISignalDI.
40621: Argument error............................User's Guide
Argument Interrupt has negative value for ITimer.
40622: Argument error............................User's Guide
The value of argument Time in Itimer is to low for cyclic interrupts.
40623: Argument error............................User's Guide
The value of argument Time in ITimer is to low for single interrupts.
Programming Error Messages (Cont)
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
To Next Page
Loading...
