Appendix B 387
Key Definitions
Softkeys displayed by pressing the [Sweep] key
B. Key Definitions
Table B-51 DC bias mode (DC Bias Mode) menu
Key operation: [Sweep] - EDIT LIST - EDIT - more 1/3 - BIAS MODE [ ]
[Sweep] - EDIT LIST - ADD - more 1/3 - BIAS MODE [ ]
[Source] - more 1/2 - MODE [ ]
Softkey Function GPIB command
VOLT
|
Selects the voltage source as the dc bias source configuration. DCMOD VOLT
CURRENT
|
Selects the current source as the dc bias source configuration. DCMOD CURR
VOLT CONSTANT
|
Sets the constant voltage source as the dc bias source configuration. The output
voltage is kept constant irrespective of the connected load. Note that the
maximum current is restricted.
DCMOD CVOLT
CURRENT CONSTANT Sets the constant current source as the dc bias source configuration. The output
current is kept constant irrespective of the connected load. Note that the
maximum voltage is restricted.
DCMOD CCURR
return Returns to the higher-level menu (Table B-49, “Segment edit (Edit Segment)
menu (2/3),” on page 385 or Table B-54, “DC bias (Source Bias) menu,” on
page 388).
(N/A)
Table B-52 List deletion (Clear List?) menu
Key operation: [Sweep] - EDIT LIST - CLEAR LIST
Softkey Function GPIB command
yes Deletes all contents of the currently edited list sweep table from the screen and
returns to Table B-47, “List sweep (List Sweep) menu,” on page 384. However,
even after all of the contents of the list sweep table have been deleted from the
screen with this key, you can reset the previously stored list sweep table by
pressing the cancel key in Table B-47, “List sweep (List Sweep) menu,” on page
384 without deleting its contents.
(N/A)
cancel Cancels the deletion of the list sweep table from the screen and returns to Table
B-47, “List sweep (List Sweep) menu,” on page 384.
(N/A)
To Next Page
Loading...
Need help?
General
