Agilent Technologies 4294A - Page 458

450 Appendix D
Initial Settings
Initial Settings, Settings that can be Saved/Recalled, Settings that can be
Backed Up
Display On/Off (GPIB Command only) On ¬¬ Ö
Backlight On/Off (GPIB Command only) On ¬¬ Ö
Trace A/B split display Off ¬¬ Ö
Trace definition Data ¬¬ Ö
Accumulate display Off ¬¬ Ö
Non-active trace display hiding Off ¬¬ Ö
Allocation (Instrument/IBASIC) All instrument No effect ¬
Level monitor
display
OSC Off ¬¬ Ö
DC bias Off ¬¬ Ö
Title blank ¬¬ Ö
Offset value 0 ¬¬ Ö
Format Linear ¬¬ Ö
Phase unit degree (°) ¬¬ Ö
Expanded phase display Off ¬¬ Ö
Scale Scale/div A: 100 kW/div
B: 36 °/div
¬¬ Ö
Reference line Position 5 div ¬¬ Ö
value A: 500 kW
B: 0 °
¬¬ Ö
Top value A: 1 MW
B: 180 °
¬¬ Ö
Bottom value A: 0 W
B: -180 °
¬¬ Ö
Scaled trace selection (Data/Memory) Data ¬¬ Ö
Coupled scale setting between Data and
Memory traces
On ¬¬ Ö
Adapter
setting
Adapter selection None No effect ¬Ö Ö
Setup data Empty No effect ¬Ö
User
calibration
On/Off Off ¬¬ Ö
Standard definition
for data measurement
Open G 0 S ¬¬ Ö
C0 F¬¬ Ö
Short R 0 W¬¬Ö
L0 H¬¬ Ö
Load R 50 W¬¬Ö
L0 H¬¬ Ö
Data measurement point setting for user calibration and
fixture compensation
Fixed ¬¬ Ö
User calibration coefficient Empty ¬¬ Ö
Port extension
compensation
On/Off Off ¬¬ Ö
Port extension value 0 ¬¬ Ö
Table D-1 Initial settings, settings that can be saved/recalled, settings that can be backed up
Function Setting
Initial settings
(factory settings)
[Preset] *RST
Save/
Recall
Backup