Agilent Technologies 4294A - Page 459

Appendix D 451
Initial Settings
Initial Settings, Settings that can be Saved/Recalled, Settings that can be
Backed Up
D. Initial Settings
Fixture
compensation
On/Off Open Off ¬¬ Ö
Short Off ¬¬ Ö
Load Off ¬¬ Ö
Standard definition
for data measurement
Open G 0 S ¬¬ Ö
C0 F¬¬ Ö
Short R 0 W¬¬Ö
L0 H¬¬ Ö
Load R 50 W¬¬Ö
L0 H¬¬ Ö
Data measurement point setting for user calibration and
fixture compensation
Fixed ¬¬ Ö
Fixture compensation coefficient Empty ¬¬ Ö
Trigger Sweep mode Continuous ¬ Hold Ö
Trigger source selection Internal (Free run) ¬¬ Ö
Polarity of external trigger signal Positive ¬¬ Ö
Trigger event mode On sweep ¬¬ Ö
Marker Marker (main marker) Off ¬¬ Ö
Sub marker Off ¬¬ Ö
Objective trace selection (Data/Memory) Data ¬¬ Ö
Trace A/B coupled mode On/Off On ¬¬ Ö
Marker movement mode (Continuous/Discrete) Continuous ¬¬ Ö
D marker mode Off ¬¬ Ö
Sweep parameter value Stimulus value ¬¬ Ö
Level monitor value display mode Off ¬¬ Ö
Marker list display Off ¬¬ Ö
Marker search Search function Off ¬¬ Ö
Target
search
Target value Off ¬¬ Ö
Target line display Off ¬¬ Ö
Peak
definition
DX value 500 kHz ¬¬ Ö
DY value 1 ¬¬ Ö
Polarity (Positive/Negative) Positive ¬¬ Ö
Search tracking function On/Off Off ¬¬ Ö
Partial
search
On/Off Off ¬¬ Ö
Search range Lower limit value 40 Hz ¬¬ Ö
Upper limit value 110 MHz ¬¬ Ö
Search
range for
List sweep
Full (All segments)/Specified segment Full ¬¬ Ö
Search segment 1 ¬¬ Ö
Search range line display Off ¬¬ Ö
Table D-1 Initial settings, settings that can be saved/recalled, settings that can be backed up
Function Setting
Initial settings
(factory settings)
[Preset] *RST
Save/
Recall
Backup