Agilent Technologies 4294A - Page 460

452 Appendix D
Initial Settings
Initial Settings, Settings that can be Saved/Recalled, Settings that can be
Backed Up
Analysis Equivalent
circuit
analysis
Equivalent
circuit model
Selection A ¬¬ Ö
Display Off ¬¬ Ö
Equivalent
circuit
parameter
Display Off ¬¬ Ö
Va l ue
0 ¬¬ Ö
Statistical analysis Off ¬¬ Ö
Trace
bandwidth
analysis
On/Off Off ¬¬ Ö
Cutoff point
definition
Definition type Fixed ¬¬ Ö
Fixed value 0 ¬¬ Ö
Waveform
analysis
(GPIB
command
only)
Analysis range Full sweep range ¬¬ Ö
Analyzed segment when sweep type is list 0 ¬¬ Ö
Analyzed trace (Data/Memory) Data ¬¬ Ö
Peak definition
0 ¬¬ Ö
Limit test On/Off Off ¬¬ Ö
Beep On/Off Off ¬¬ Ö
Limit line table Empty ¬¬ Ö
Limit range
offset
Limit value (X-axis) offset 0 ¬¬ Ö
Sweep parameter value (Y-axis) offset 0 ¬¬ Ö
Save, recall
and so on
Contents selection
for saving data arrays
Data array Off ¬¬
Memory array Off ¬¬
Data trace array On ¬¬
Memory trace array On ¬¬
User calibration data and fixture
compensation data array
Off ¬¬
Storage device selection Floppy Disk Drive No effect ¬Ö
Status report
structure
(GPIB
command
only)
Service request enable register value 0 No effect ¬
Standard event status enable register value 0 No effect ¬
Instrument event status enable register value 0 No effect ¬
Operation status enable register value 0 No effect ¬
Positive transition filter value of operation status register 0 No effect ¬
Negative transition filter value of operation status
register
0 No effect ¬
LAN/GPIB 4294A IP address 0.0.0.0 No effect ¬Ö
Gateway IP address 0.0.0.0 No effect ¬Ö
Subnet mask 0.0.0.0 No effect ¬Ö
4294A GPIB address 17 No effect ¬Ö
Controller GPIB address 21 No effect ¬Ö
Table D-1 Initial settings, settings that can be saved/recalled, settings that can be backed up
Function Setting
Initial settings
(factory settings)
[Preset] *RST
Save/
Recall
Backup