File
5
SYSTEM MESSAGESMAINTENANCE
Ed. 04 11/24Réf. 3EH 21000 BSAA
90 ENTERING AN MMC SESSION CPU (80) INFO 0 = 1: ADMINISTRATOR
password; 2: INSTALLER pas-
sword; 3: OPERATOR password;
5: protected access
91 QUITTING AN MMC SESSION CPU (80)
100 BOARD BACK IN SERVICE
(Following a system stoppage or
after being unplugged)
Board lo-
cation
INFO 0 = type of board
101 BOARD DISCONNECTION Board lo-
cation
INFO 0 = type of board (if
known)
104 TEMPORARY BOARD RESET Board lo-
cation
INFO 0 = 1: hardware fault; 2:
no response from board; 3: fan
fault; 4: running on battery; 5: li-
cense problem; 6: maintenance
problem; 7: reason unknown
INFO 1 = cause of reset
105 PERMANENT BOARD RESET Board lo-
cation.
INFO 0 = 1: hardware fault; 2:
no response from board; 3: fan
fault; 4: running on battery; 5: li-
cense problem; 6: maintenance
problem; 7: reason unknown; 8:
power supply problem
INFO 1 = cause of reset
Discon-
nect and
reconnect
the
board. If
the fault
persists,
replace
the board
106 BOARD REFUSED
The board has been refused and,
in the case of a digital board, a
permanent reset is performed on
it
Board lo-
cation
INFO 0 = type of board
INFO 1 = cause of refusal
Check the
hardware
configu-
ration (the
system li-
mits may
have
been ex-
ceeded)
107 MMC BOARD RESET
The reset of an interface board
processor has been requested by
MMC
Board lo-
cation
TYPE MESSAGE LOCA-
TION
ADDITIONAL INFORMATION ACTION
To Next Page
Loading...
