EasyManuals Logo

Alcatel OmniPCX Office Technical Documentation

Alcatel OmniPCX Office
964 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #930 background imageLoading...
Page #930 background image
SYSTEM MESSAGES MAINTENANCE
Ed. 0412/24 Réf. 3EH 21000 BSAA
108 POWER DOWN: LAUNCH OF
BACKUP PROCEDURE FOR A GI-
VEN BOARD
Board lo-
cation
110 APPEARANCE OF A TERMINAL
A terminal has been recognized
by the system. This terminal is
now operational
NB: this message will only be sent
if the NMC is present and active
Board lo-
cation.
Interface
marker
INFO 0 = type of terminal
111 TERMINAL REFUSED
Configuration limit attained
Board lo-
cation.
Interface
marker
INFO 0 = type of terminal
INFO 1 = cause of refusal
INFO 2 = 1 (software license
problem; in this case, INFO 1 =
255 (terminal not totally refused,
because recognized by MMC)
Check the
hardware
configu-
ration (the
system li-
mits may
have
been ex-
ceeded).
112 FAULT ON A TERMINAL Board lo-
cation.
Interface
marker
INFO 0 = type of terminal
INFO 1 = type of error
If the fault
recurs fre-
quently,
check the
terminal
and its
connec-
tions.
113 INTERFACE REFUSED
An interface was refused because
the system limits were exceeded
Board lo-
cation.
Interface
marker
INFO 0 =type of interface Check the
hardware
configu-
ration (the
system li-
mits may
have
been ex-
ceeded).
TYPE MESSAGE LOCA-
TION
ADDITIONAL INFORMATION ACTION

Table of Contents

Other manuals for Alcatel OmniPCX Office

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Alcatel OmniPCX Office and is the answer not in the manual?

Alcatel OmniPCX Office Specifications

General IconGeneral
VoIP SupportYes
SIP SupportYes
ISDN SupportYes
Analog SupportYes
Integrated Voice MailYes
Auto AttendantYes
ConferencingYes
VoIP ProtocolsSIP, H.323
Power Supply100-240 VAC, 50/60 Hz
Network Interfaces10/100 Mbps Ethernet
Humidity10% to 90% non-condensing