2.1 Before Measurement
HA-8190V 2-5
Whole blood pair rack [White, WBlood PAIR]
Hemolysis pair rack [Orange, HEMOL. PAIR]
Anemia rack [White, ANEMIA]
Use Normal measurement. Use this rack to measure whole blood sample in sample cups. Sample
IDs are read from the barcode labels attached to sample tubes.
Object Whole blood sample
Adapter Odd-numbered ports: Port guide (blue)
Even-numbered ports: Port guide (gray)
Sample container Odd-numbered ports: Sample tubes (for barcode labels)
Even-numbered ports: Sample cups (sample)
Use Normal measurement of hemolysis samples. Prepare samples in sample cups. Sample IDs are
read from the barcode labels attached to sample tubes.
Object Hemolysis sample
Adapter Odd-numbered ports: Port guide (blue)
Even-numbered ports: Port guide (gray)
Sample container Odd-numbered ports: Sample tube (for barcode labels)
Even-numbered ports: Sample cup (sample)
IMPORTANT:
Do not set whole blood samples in the even-numbered ports of the hemolysis pair rack to avoid seriously
degrading the column. If whole blood is measured in these ports, it is recommended to replace the column with
a new one.
Use Normal measurement of anemia samples (whole blood)
Object Whole blood sample
Adapter Port guide (gray)
Sample container Sample tube
IMPORTANT:
Use the anemia rack for whole blood samples from patients previously diagnosed as anemic. Measuring
non-anemia samples with the anemia rack may cause inaccurate measurement results.
To Next Page
Loading...
Need help?
General
