Arkray ADAMS A1c - Viewing Measurement Results in Detail

Chapter 2 Measurement
HA-8190V 2-24
3 Once measurements are complete for all set samples (end of a batch)
 “Waiting for meas. to end”
• The tubes will be cleaned after all sample measurements are
complete.
• The standby screen will then appear again.
a Check that the sample racks are not moving.
b Remove the sample racks from the rack unloading side of the sampler.
4 At the end of the day...
a Press the standby switch to turn off the power.
2.5.3 Viewing Measurement Results in Detail
Peak information and chromatograms of measurement results obtained in the current batch can be displayed during
measurement.
1 View the measurement results.
a While “Measuring ...” is being displayed, touch .
• Only available options will appear on the [Main menu] screen.
REFERENCE:
If <Data list> is set to <Print>, the lists below can be printed out
after a batch of measurements is complete.
• List of measurement results
• List of abnormal results
• List of barcode errors
NOTE:
Remove the sample racks so that they do not fall over. Spilled sample may damage the instrument.
REFERENCE:
The instrument can be set so that it automatically enters sleep mode after measurements or tube washing. See
“3.3.2. Setting the Startup Timer and Entering the Sleep Mode” on page 3-6.
MENU