AudioCodes Mediant 500L MSBR

User's Manual 1006 Document #: LTRT-10466
Mediant 500L MSBR
Parameter Description
For a description of this table, see ''Configuring Redirect Number
Manipulation'' on page 391.
Phone Context Table
Web: Phone Context Table
EMS: SIP Manipulations >
Phone Context
CLI: configure voip > gw
manipulations phone-
context-table
[PhoneContext]
This table parameter configures the Phone Context table. This
parameter maps NPI and TON to the SIP 'phone-context' parameter,
and vice versa.
The format for this parameter is as follows:
[PhoneContext]
FORMAT PhoneContext_Index = PhoneContext_Npi,
PhoneContext_Ton, PhoneContext_Context;
[\PhoneContext]
For example:
PhoneContext 0 = 0,0,unknown.com
PhoneContext 1 = 1,1,host.com
PhoneContext 2 = 9,1,na.e164.host.com
For a detailed description of this table, see ''Configuring NPI/TON-SIP
Phone-Context Mapping Rules'' on page 396.
Web/EMS: Add Phone
Context As Prefix
CLI: add-ph-cntxt-as-pref
[AddPhoneContextAsPre
fix]
Determines whether the received Phone-Context parameter is added as
a prefix to the outgoing ISDN Setup message with (for digital interfaces)
Called and Calling numbers.
 [0] Disable (default)
 [1] Enable
67.11 SBC Parameters
The SBC and CRP parameters are described in the table below.
Table 67-70: SBC and CRP Parameters
Parameter Description
CRP-specific Parameters
Web: CRP Application
EMS: Enable CPR Application
CLI: enable-crp
[EnableCRPApplication]
Enables the CRP application.
 [0] Disable (default)
 [1] Enable
Note: For this parameter to take effect, a device reset is required.
Web: CRP Survivability Mode
CLI: crp-survivability-mode
[CRPSurvivabilityMode]
Defines the CRP mode.
 [0] Standard Mode (default)
 [1] Always Emergency Mode
 [2] Auto-answer REGISTER
CLI: crp-gw-fallback
[CRPGatewayFallback]
Enables fallback routing from the proxy server to the Gateway
(PSTN).
 [0] = Disable (default)
 [1] = Enable
SBC-specific Parameters
Web/EMS: Enable SBC
CLI: enable-sbc
[EnableSBCApplication]
Enables the Session Border Control (SBC) application.
 [0] Disable (default)

[1]
Enable