AudioCodes Mediant 500L MSBR

User's Manual 1026 Document #: LTRT-10466
Mediant 500L MSBR
67.14 Services
67.14.1 SIP-based Media Recording Parameters
The SIP-based media recording parameters are described in the table below.
Table 67-73: SIP-based Media Recording Parameters
Parameter Description
Web: SIP Recording Application
CLI: configure voip/services sip-
recording general-
setting/enable-sip-rec
[EnableSIPRec]
Enables the SIP-based Media Recording feature:
 [0] Disable (default)
 [1] Enable
Note: For this parameter to take effect, a device reset is required.
Web: Recording Server (SRS)
Destination Username
CLI: configure voip/services sip-
recording general-
setting/siprec-server-dest-
username
[SIPRecServerDestUsername]
Defines the SIP user part for the recording server. This user part is
added in the SIP To header of the INVITE message that the device
sends to the recording server.
The valid value is a string of up to 50 characters. By default, no
user part is defined.
SIP Recording Routing Table
Web: SIP Recording Routing
table
CLI: configure voip/services sip-
recording sip-rec-routing
[SIPRecRouting]
Defines SIP Recording Routing rules (calls to record).
The format of the ini file table parameter is as follows:
[ SIPRecRouting ]
FORMAT SIPRecRouting_Index =
SIPRecRouting_RecordedIPGroupID,
SIPRecRouting_RecordedSourcePrefix,
SIPRecRouting_RecordedDestinationPrefix,
SIPRecRouting_PeerIPGroupID,
SIPRecRouting_PeerTrunkGroupID, SIPRecRouting_Caller,
SIPRecRouting_SRSIPGroupID;
[ \SIPRecRouting ]
For a detailed description of this table, see ''Configuring SIP
Recording Routing Rules'' on page 217.
67.14.2 RADIUS and LDAP Parameters
67.14.2.1 General Parameters
The general RADIUS and LDAP parameters are described in the table below.
Table 67-74: General RADIUS and LDAP Parameters
Parameter Description
Web: Use Local Users Database
CLI: configure system > mgmt-
auth > use-local-users-db
[MgmtUseLocalUsersDatabase]
Defines when the device uses its local user database (Web Users
table) for LDAP- or RADIUS-based management-user login
authentication.
 [0] When No Auth Server Defined = (Default) When no
LDAP/RADIUS server
is configured (or as fallback if the server
is inaccessible).