AudioCodes Mediant 500L MSBR

User's Manual 64. Pinging a Remote Host or IP Address
Version 6.8 771 Mediant 500L MSBR
64 Pinging a Remote Host or IP Address
You can verify the network connectivity with a remote host or IP address by pinging the
network entity.

IPv4: The ping to an IPv4 address can be done from any of the device's VoIP or data-
router interfaces that is configured with an IPv4 address. The ping is done using the
following CLI command:
# ping <IPv4 ip address or host name> source [voip|data]
interface

IPv6: The ping to an IPv6 address can be done only from a data-router interface and
that is configured with an IPv6 address. The ping is done using the following CLI
command:
# ping ipv6 <IPv6 address or host name> source data [vrf | source-address interface|
interface] [size <max. IP packet size>] [repeat <1-300>]
For a complete description of the ping command, refer to the CLI Reference Guide.
Note: IPv6 ping is currently only supported on Ethernet and Fiber interfaces.