AudioCodes Mediant 500L MSBR

User's Manual 8. Web-Based Management
Version 6.8 71 Mediant 500L MSBR
8.4 Displaying Login Information upon Login
The device can display login information immediately upon Web login.
 To enable display of user login information upon a successful login:
1. Open the Web Security Settings page (Configuration tab > System menu >
Management > Web Security Settings).
2. From the 'Display Login Information' drop-down list, select Yes.
3. Click Submit.
Once enabled, the Login Information window is displayed upon a successful login, as
shown in the example below:
Figure 8-20: Login Information Window
8.5 Configuring Web Security Settings
The Web Security Settings page is used to configure security for the device's Web
interface.
By default, the device accepts HTTP and HTTPS access. However, you can enforce
secure Web access communication method by configuring the device to accept only
HTTPS.
For a description of these parameters, see ''Web and Telnet Parameters'' on page 779.
 To define Web access security:
1. Open the Web Security Settings page (Configuration tab > System menu >
Management > Web Security Settings).
2. Set the 'Secured Web Connection (HTTPS)' parameter to HTTPS Only.
3. Configure the parameters as required.
4. Click Submit.
5. To save the changes to flash memory, see ''Saving Configuration'' on page 606.