AudioCodes Mediant 500L MSBR

User's Manual 886 Document #: LTRT-10466
Mediant 500L MSBR
67.10 Gateway and IP-to-IP Parameters
67.10.1 Fax and Modem Parameters
The fax and modem parameters are described in the table below.
Table 67-38: Fax and Modem Parameters
Parameter Description
Web: Fax Transport Mode
EMS: Transport Mode
CLI: fax-transport-mode
[FaxTransportMode]
Determines the fax transport mode used by the device.
 [0] Disable = transparent mode
 [1] T.38 Relay (default)
 [2] Bypass
 [3] Events Only
Note: This parameter is overridden by the parameter
IsFaxUsed. If the parameter IsFaxUsed is set to 1 (T.38 Relay)
or 3 (Fax Fallback), then FaxTransportMode is always set to 1
(T.38 relay).
EMS: V34 Transport Method
CLI: V34-fax-transport-type
[V34FaxTransportType]
Determines the V.34 fax transport method (whether V34 fax falls
back to T.30 or pass over Bypass).
 [0] = Transparent
 [1] = (Default) Relay
 [2] = Bypass
 [3] = Transparent with Events
Note: To configure V34FaxTransportType to 1 (i.e., fax relay),
you also need to configure FaxTransportMode to 1 (fax relay).
Web: V.21 Modem Transport Type
EMS: V21 Transport
CLI: V21-modem-transport-type
[V21ModemTransportType]
Determines the V.21 modem transport type.
 [0] Disable = (Default) Transparent.
 [2] Enable Bypass
 [3] Events Only = Transparent with Events.
Note: You can also configure this functionality per specific calls,
using IP Profiles (IpProfile_VxxTransportType). For more
information, see ''Configuring IP Profiles'' on page 332.
Web: V.22 Modem Transport Type
EMS: V22 Transport
CLI: V22-modem-transport-type
[V22ModemTransportType]
Determines the V.22 modem transport type.
 [0] Disable = Transparent.
 [2] Enable Bypass (default)
 [3] Events Only = Transparent with Events.
Note: You can also configure this functionality per specific calls,
using IP Profiles (IpProfile_VxxTransportType). For more
information, see ''Configuring IP Profiles'' on page 332.
Web: V.23 Modem Transport Type
EMS: V23 Transport
CLI: V23-modem-transport-type
[V23ModemTransportType]
Determines the V.23 modem transport type.
 [0] Disable = Transparent.
 [2] Enable Bypass (default)
 [3] Events Only = Transparent with Events.
Note: You can also configure this functionality per specific calls,
using IP Profiles (IpProfile_VxxTransportType). For more
information, see ''Configuring IP Profiles'' on page 332.
Web: V.32 Modem Transport Type
EMS: V32 Transport
CLI: V32-modem-transport-type
Determines the V.32 modem transport type.
 [0] Disable = Transparent.

[2]
Enable Bypass (default)